Introducing construction manual

lang

Installation Manual

Easy installation to existing glass regardless of location.

Crystal Magic Film
construction manual

【Construction Procedure】

  1. Clean the glass. Clean every corner with a glass cleaning blade, rubber wiper, with a 5% neutral detergent aqueous solution, and dry thoroughly.
  2. Place the crystal magic film on a flat table and solder the lead wire (about 40 cm) to the terminal.
  3. Use a non-woven fabric to remove dust from the liner paper side of the crystal magic film and clean it.
  4. Temporarily mount the crystal magic film on the glass, peel off the liner paper by about 30 to 40 cm, and temporarily attach it to the glass.
    Check that the film is not misaligned, gradually peel off the backing paper, and attach it to the glass with a squeegee wrapped in cloth.
    If dust or dirt is found at that time, mark it with a pen, remove the film, and remove the dust with cellophane tape.
  5. Insulate the bus bar with a special silicone insulating tape.
  6. Wire to the controller. Check the connection with the dedicated controller.
  7. Make a connection with AC100V and the switch, and check if it works without problems.
  8. Remove the protective film on the film surface.
  9. Construction of caulking* and ridge   (*Please be sure to use the one specified by the manufacturer for caulking)

【Care after construction】

You can clean the crystal magic film with a soft cloth like a normal film, but be careful not to get water on the edges of the film. There is a possibility of an electrical short circuit.

If the crystal magic film is energized for about 8 hours, re-energize it for 1 hour or more, and then re-energize it after de-energizing.

Dedicated controller

Crystal Magic Glass
construction manual

【Construction Procedure】

  1. Clean inside the frame
  2. Installation of setting block and backup material
  3. Glass installation
  4. Line
  5. Wire to the controller
  6. Construction of caulking* and ridge   (*Please be sure to use the one specified by the manufacturer for caulking)

【Notes on measuring Crystal Magic Glass】

The terminal part of the crystal magic glass is pre-applied with a vinyl chloride cover. Taking FL5 + FL5 crystal magic glass as an example, it will be as shown in the figure below, so please decide the size taking into consideration the swallowing of the glass.
If you need to drill holes, chamfer the glass edge, or polish it, please specify.


【Care after construction】

You can clean the crystal magic glass with a soft cloth soaked in water like normal glass, but be careful not to get water on the middle layer of the laminated glass. There is a possibility of an electric short circuit.

If the crystal magic glass is energized for about 8 hours, re-energize it for 1 hour or more, and then re-energize it after de-energizing.

Dedicated controller